Emc navisphere agent

Agent uses TCP port - make sure this is not blocked by firewalls. This content has been marked as final. You can not post a blank message. Yes you can, I just needed to know where to get the NaviAgent for our disaster recovery documentation.

Uploader: Gardagor
Date Added: 8 March 2011
File Size: 12.54 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 82121
Price: Free* [*Free Regsitration Required]





Install EMC Navisphere Agent on VMware ESX Server

Yes you can, I just needed to know where to get the NaviAgent for our disaster recovery documentation. Below are the current solutions for Navisphere Host Agent - some of these may be for older releases.

Go to original post. There are a number of naviphere places to find documentation for setting up and configuring the Navisphere Host Agent.

Install EMC Navisphere Agent on VMware ESX Server

Best Practices and general configuration information. I had the same problem yesterday. You can not post a blank message. Do not check this box unless you have installed PowerPath first or other multi-path softwareotherwise the initiators will not register with the array.

Please check the solution for the version, if available. I need the vmware naviagent 6. In the Log On session in the Targets tab, the "Log on to Navis;here screen has two check boxes - one for persistent connections restore on reboot that the other to "Enable Multi-path".

Navisphere Server Utility for arrays running flare version 29 and earlier and the new Unisphere Server Utility for Release This tool uses JavaScript and much of it will not work correctly without it enabled.

EMC Community Network - DECN: Navisphere agent download

You don't have JavaScript enabled. Email Address Required, will not be published. Navisphere host agent not registering correctly. Not sure it wouldn't be free since it does nothing for you without a Clariion. Loading any pathing software or agents on ESX is not supported, or at least the last time I reviewed the documentation.

CuAt is blank after starting the Unisphere agent. This content has been marked as final. Oryou must have Partner access.

You don't have a path to your clariion service provider? Please type your message and try again. Installation issues — is the correct version of Agent installed and running - make sure that the latest version of Agent is installed.

Navisphere Management Suite

Correct Answers - 10 points. Thanks for pointing that out.

Please enter a title. Normally this is done when setting up a new host. I had solved the same problem, i.

Please review all documentation prior to installing and setting up Agent. Problems with Agent and host registration can be broken down to three areas: See emc for issues with paths not connecting to correct Storage Group.

Hosts show as "Unmanaged" in Navisphere. Host registers with the incorrect host IP address or the incorrect host name.

Even PowerPath has a free version. And VMware support has said this so many times to us, I have lost count.

4 thoughts on “Emc navisphere agent

  1. In my opinion you are not right. I am assured. I can defend the position. Write to me in PM, we will talk.

Leave a Reply

Your email address will not be published. Required fields are marked *